The Ash generated by the use of Bagasse and coal as fuel is needed to
be handled very carefully as it pollutes air and water. Group Engineers
is the master in doing so.
1. Location of Conveying :
Various discharge points of Boilers to conveys The wet and dry ash
from various discharge points of Boilers to Ash storage Silo including
sub-merged Belt Conveyor to Silo with structure.
2. Belt Sizes :-500 mm to 1000 mm .
3. Screw Size :-Dia 300 and 400 mm.
4. Belt capaclty :-2 TPH to 25 TPH.
5. Power Generated :-10 MW to 52 MW
6. Design :-System designed as per IS : 11529 and structural material ( Belt, pulley, idler etc.)
and structural material as per IS standard.
Following codes and standards shall be followed :-
IS 11592 (2000): Code of practices for the selection and design of the conveyor.
IS 1891 : Specification for rubber conveyor part-1. IS 477 : Specification for the troughed Belt Conveyor for surface
installation part I and /I ( For under Ground). IS 7155 : Code of the Practice for the Conveyor Safety. IS 8466 : Bagasse Carrier Chain. IS 8531 : Specification for pulley for Belt Conveyors. IS 8598 : Specification for the Idlers for Belt Conveyors. IS 14206 : Mechanical joining of plied textile reinforced Rubber
Conveyor. IS 1554 : PVC insulated Cables. IS 3043 : Code of Practices of Earthing.
Achievement :-
Group Engineers is proud to declare about the satisfactory working of the
system of 2 TPH to 25 TPH capacity in many plant.
The full proof system is complete as considering all the Design Parameters
such as the location, mean Baromatric pressure, Wind Velocity, Rainfall, Relative
Humidity and many other parameter
The design manufacture testing and performance of the system shall comply
with all currently applicable status, regulating and safety codes in the locality where
the equipments will be installed.
The equipments offered by Group Engineers shall be capable for rated capacity
of Fuel & designed for smooth continuous operation with easy maintainence.
